Crumbling dry rot in a white soffit and fascia board along a roofline
Clark County Rot Specialists

Dry Rot Repair Contractor in Vancouver, WA

Rot Busters is a specialist dry rot repair contractor in Vancouver, WA. Rot rarely starts where you see it. We trace the water back to where it is getting in and fix the source, so you are not paying to repair the same corner again. We handle siding, decks, window trim, framing, and structural rot across Clark County.

The Short Answer

What Does a Dry Rot Repair Contractor Do?

A dry rot repair contractor fixes the wood rot that water causes once moisture gets into a home and cannot dry out. At Rot Busters, that covers siding, framing and sheathing, and major structural rot in beams and floor systems, along with the window trim and fascia where rot so often starts. The work is not just replacing bad wood. It is finding where the water got in and fixing that too, so the repair lasts.

See Our Full Process
Fresh lumber replacing rotted window casing at a frame corner under cedar shake siding
Why Rot Busters

What You Get With Every Job

Rot repair is rarely covered by insurance, so Clark County homeowners usually pay for it out of pocket. Here is what that money gets you when you hire us.

Licensed Washington contractor, License #ROTBUBL748OH.
Fourteen years of combined construction experience, including three years spent at a dedicated rot repair company in the Seattle metro.
Fixed-price, itemized quotes based on site conditions and the size of the area, so you know the cost before work starts.
A one-year workmanship guarantee. If anything fails within a year due to our installation, we make it right.
Financing available through our payment portal when paying out of pocket all at once is not ideal.
Emergency callouts for active leaks or structural concerns, though we are not a 24/7 service.
Family-owned and based in Vancouver, serving Clark County homeowners.
Book an inspection today
Caulk Fails, Water Gets In

Siding Rot Repair

Your siding is the first thing standing between the weather and your framing, and in the Pacific Northwest it takes a beating. When caulk joints fail, boards crack, or flashing was skipped, water slips behind the cladding and feeds rot you cannot see from the outside.
‍
We repair the siding and the decay underneath it, then correct the detail that let the water in. That might mean new flashing, proper drainage, or replacing trim that was never sealed right.
‍
The result is siding rot repair that fixes the cause, not just the damage, so the same wall is not rotting again in a couple of seasons.

Self-adhering flashing membrane over wall sheathing at a roof-to-wall window junctionExterior lap siding panels adjacent to roof shingles, gutter line, window frame, and soffit trim.
Multi-level scaffolding against a blue and brown home during exterior siding rot repair
Key Points
We repair the rot and the source of the water, not just the visible damage.
Failed caulk and trim joints are among the most common entry points, so we address them directly.
We rebuild with moisture-resistant materials suited to the wet Clark County climate.
Learn more about Siding Rot Repair
The Leak at Your Windows and Roofline

Window Trim & Fascia Replacement

Window trim and fascia are among the most common places rot starts on a PNW home. Caulk is a maintenance item, not a permanent seal, and once it fails water works straight into the frame and the boards behind it.
‍
We handle window rot repair and fascia replacement, pulling the rotted wood, fixing the flashing behind it, and rebuilding so water runs off instead of pooling against the frame.
‍
Caught at the trim, this is a small job. Left alone, the same water keeps moving into the wall and the framing behind it, and a quick fix becomes a much larger one.

Exterior lap siding panels adjacent to roof shingles, gutter line, window frame, and soffit trim.Fresh lumber replacing rotted window casing at a frame corner under cedar shake siding
Extension ladder against a home's fascia, soffit, and gutter corner during rot repair
Key Points
We replace rotted trim and fascia, then fix the flashing that let water in.
Caulk failure is a common cause, so we fix the flashing behind it and reseal with a flexible polyurethane sealant instead of running a fresh bead over old caulk.
Early repair here keeps a trim problem from becoming a framing problem.
Book an inspection today
Where Decks Let You Down

Waterproof Deck Systems

A deck that cannot shed water does not just rot itself. It rots the ledger, the framing below, and the wall it attaches to. That connection to the house is a common way water gets into a structure.
‍
We build waterproof deck systems that keep water off the framing underneath and out of the living space below, with the flashing and slope set to drain properly from day one.
‍
Done right, the deck protects the house instead of feeding water into it, holding up through season after season of Clark County rain.

Grey waterproof membrane coating on an upper-level balcony deck meeting light grey sidingCompleted balcony deck waterproofing system protecting exterior walls and garage overhang from rot.
Light grey waterproof deck coating on an upper-level balcony with white metal guardrails
Key Points
The deck-to-house connection is a frequent water entry point, so we flash and detail it carefully.
A waterproof surface protects the framing below and any living space underneath.
Built to drain, so a wet winter does not turn into a structural repair.
Book an inspection today
Soft Boards, Hidden Risk

Wood Deck Repair

Rotted joists, posts, and decking boards make a deck unsafe long before it looks that way from the surface. By the time a board feels soft underfoot, the framing beneath it has usually been wet for a while.
‍
Our deck rot repair replaces the compromised wood and reinforces the connections and hardware, so the deck is sound where it carries weight, not just solid where you can see it.
‍
A soft joist or post is a safety problem before it is a looks problem, so we rebuild the structure itself rather than resurfacing over wood that is already going.

Rebuilding rotted deck joists, ledger boards, and support posts to restore structural safety.Elevated deck rebuilt on new support posts and framing after a deck rot repair
Elevated balcony deck rebuilt after structural joist and framing rot repair
Key Points
We replace rotted joists, posts, and boards, rebuilding with TimberTech composite decking where you want a low-maintenance surface.
Connections and hardware are reinforced so the deck is sound where it carries weight.
We rebuild the structure rather than resurfacing over wood that is already failing.
Book an inspection today
When the Frame Goes Soft

Frame Rot Repair

The frame is what holds your house up, so when water reaches it and the wood stays wet, that strength starts to go. Studs, plates, and sheathing lose their integrity, and the problem spreads to whatever is next to it.
‍
Our frame rot repair removes the rotted studs, plates, and sheathing, treats the surrounding area, and rebuilds with new lumber, while correcting whatever let water reach the frame.
‍
Fixing the framing without fixing the water is how rot returns, so we handle both in the same repair.

Opened two-story wall showing water-damaged studs, exposed insulation, and plumbing pipesWood rot behind exterior siding, showing rotted plywood sheathing and exposed wall insulation
Wall reframing on a multi-level house after removing rotted siding and damaged sheathing
Key Points
We replace rotted studs, plates, and sheathing, then address what let water in.
The surrounding area is treated to stop the decay from spreading.
We rebuild with new lumber, not the wood that failed before.
Book an inspection today
The Repair You Cannot Put Off

Structural Rot Repair

Beams, floor joists, and rim joists carry the load of your home, so any rot in them is a safety issue, not a cosmetic one. Left alone, a compromised member can lead to sagging floors or worse.
‍
Structural rot repair starts with shoring and support so the house is held safely while we work. We replace the failed beams or joists, then tie everything back in with structural connectors and hardware.
‍
Because these members are critical, we do not patch around them. We restore the structure’s strength and stop the decay before it travels further into the home.

Tape measure assessing rotted structural framing before a joist and beam repairStructural remediation exposing rotted rim joists and wall studs at roof-to-wall intersections.
Bathroom wall opened to the studs to expose water-damaged framing before structural repair
Key Points
We shore and support the structure before removing any load-bearing member.
Failed beams and joists are replaced and tied in with engineered hardware.
We rebuild the frame to carry its load again, not a temporary fix.
Learn more about Structural Rot Repair
Where We Work

Rot Repair for Every Corner of Clark County

From Vancouver out to Ridgefield, Battle Ground, and Washougal, we repair rot for homeowners across the county, including:

●

Vancouver

●

Camas

●

Washougal

●

Battle Ground

●

Ridgefield

●

Hockinson

●

Brush Prairie

●

Orchards

●

Felida

●

Proebstel

Rot Busters ghost mascot in a shield

Soft wood or peeling paint?

We'll find where the water's getting in, then fix the rot at the source.

Straight Answers

Rot Repair FAQs for Vancouver, WA Homeowners

What are the signs of dry rot in my home?

Look for wood that feels soft or spongy, paint that bubbles or peels in one area, dark staining, swollen trim, or a musty smell near a wall or window. Rot that reaches the surface is usually well underway behind it.

What areas of a house are most likely to rot in the PNW?

Window and door frames, fascia, deck ledgers, and the bottoms and corners of siding. These are the spots where Clark County's long wet season finds its way in and stays against the wood.

Is dry rot repair covered by homeowners insurance?

Usually not. Rot is treated as a maintenance issue rather than sudden damage, so it almost always comes out of pocket. That is one more reason to repair it early, while the affected area is still small.

What causes so much dry rot on homes in the Vancouver area?

The Pacific Northwest's long, damp season keeps wood wet for months at a time. When siding, flashing, or trim lets water in and will not let it dry out, the wood stays saturated and rot takes hold. We see it regularly on homes across Clark County.

How long does a rot repair job take?

It depends on scope. Window and trim repairs often take one to two days, siding repairs one to three, framing and structural repairs two to four, and waterproof decks about five to seven. We give you a timeframe with your quote.

What happens if I put off rot repair until next year?

Rot does not pause. It keeps spreading through the framing it can reach, and another wet season gives it months to grow. A small trim repair this year can become a structural repair next year, at a much higher cost.

Do you guarantee your work?

Yes. We stand behind every repair with a one-year workmanship guarantee. If anything fails within that year because of our installation, we come back and take care of it.

How much does rot repair cost?

Every rot repair job is quoted as a fixed price based on the site conditions and the size of the affected area, so you get an itemized number before any work starts. Structural repairs start around $2,500, though most jobs are scoped only after we see what the water has reached.

Do you offer financing?

Yes. You can spread the cost through our payment portal, which helps when paying out of pocket all at once is not ideal, especially since rot repair is rarely covered by insurance.

Schedule Your Rot Repair Today

Have rot, or think you might? Send us a few details and we'll be in touch to set up a look. For active leaks or urgent structural concerns, call us and ask about an emergency callout.

Monday–Saturday, 8 AM–6 PM
Get Your Free Rot Repair Quote

Have rot, or think you might? Send us a few details and we will get right back to you. For active leaks or urgent structural concerns, call us and ask about an emergency callout.

By submitting, you agree to our Privacy Policy.
Thank you! Your submission has been received!
Oops! Something went wrong while submitting the form.