Soft floors, sagging framing, or a rotted beam? Our structural wood rot repair crew in Vancouver, WA traces the water source and rebuilds the structure to hold. Request a fixed-price estimate.
Water gets in where you cannot see it. It slips behind siding, pools under a crawl space, soaks into wood that never dries out. Then the fungus starts.
Wet framing is food for decay fungus. It eats the wood from the inside, so a beam can look fine on the surface while losing the strength that holds your floor up. Left alone, the damp invites black mold and termites, and both spread through the home looking for more wet wood. Wood rot in a crawl space is the quiet version of this, out of sight until a floor starts to sag.
Here is the part most homeowners do not expect: insurance usually treats rot as a maintenance problem, not a covered loss. That means the repair comes out of pocket, and every month you wait, the scope of it grows.




Structural rot is stressful enough without a vague quote and a crew learning on your house. We specialize in rot repair, so you get a straight scope and a price you can plan around.
Every job is backed by our one-year workmanship guarantee, and we are a local family crew you can reach when you have a question.
Structural rot usually shows up in three parts of a home: the walls, the floor system, and the beams that carry the load. We repair all three, and we correct the water source behind each so it doesn’t keep coming back.

Rotted studs, top and bottom plates, and exterior sheathing get removed and replaced. We brace the wall, cut out the bad members, and rebuild with new lumber tied in correctly.

Rotted floor joist repair rarely stops at one piece. We handle subfloor repair and replace floor joists and rim joists, and sister in new joists when the ends are gone but the span holds.

Beams carry serious load, so rotted beam repair is never optional. We shore and support the structure, replace it with an engineered PSL or glulam beam, and tie it back in with Simpson Strong-Tie hardware.
See the difference for yourself. Below are finished repairs from recent projects across Clark County, from opened-up framing to finished, load-bearing repairs.
We visit in person to see the problem and hear your concerns. Drawing on years of dedicated rot repair experience, we walk the affected areas with you and start planning the fix around your home and schedule.
Once we open things up, our crew inspects for hidden moisture and decay. We trace the damage back to its root cause and map a clear scope of work so you know what the job involves before it starts.
After you approve the plan, we remove every rotted member and support the structure as we go. We treat what stays, reinforce the weak points, and rebuild with high-grade, moisture-resistant materials built to last.
Wrapping up, we check every repair against our standards and walk you through the finished work. You see exactly what was done and how the structure ties back together, and the repair is backed by our one-year workmanship guarantee.
We'll find where the water's getting in, then fix the rot at the source.
Most homes in Vancouver, WA are wood-framed, and once that framing stays wet it can sag or fail. Structural wood rot is decay in the load-bearing wood of your home: the beams, joists, studs, and wall framing that hold everything up. It is not a surface problem. It is lost strength.
It starts with water. When framing gets wet from a leak, bad flashing, or crawl space moisture and cannot dry out, a decay fungus takes hold and eats the fibers that give the wood its strength. The wood turns soft, dark, and crumbly until the member can no longer carry its load.
In the Pacific Northwest, where damp is a way of life, this moves faster than most homeowners realize.
That is why we fix the cause, not just the damage. Our team brings 14 years of combined construction experience, including three years at a dedicated rot repair company in the Seattle area, learning how a home’s weather control layers work: what is meant to shed water and what is meant to breathe. Swap a rotted board without correcting why it got wet, and you’ll pay to fix the same spot twice.
Structural rot hides until it gets bad, so the early signs are easy to miss. If you notice any of these around your home, it is worth a look before the damage spreads.
Watch for these inside and out:
One or two of these can mean the rot is still small. Several together can mean it has reached the framing, and that is when it pays to have a specialist open it up.
Rot follows water, and water collects in the same few places. Knowing where to look is half the job, and it is where a specialist pulls ahead of a general contractor.
These are the spots we check first.
Crawl space wood rot is one of the most common and least seen. Ground moisture rises, damp air sits against the wood, and decay works out of sight. The wood closest to the earth stays wet the longest.
The sill plate rests on the foundation and the rim joist caps the floor edge, so both sit low and catch runoff and splashback first. Rim joist replacement is common on homes with poor grading or failed flashing.
Floor joists carry your floor, so when they rot the span loses support from below. Rotting floor joists in a crawl space often trace back to a plumbing leak or standing water that never cleared.
A main beam holds up a whole section of house, so rot here is the most serious kind. A failing beam puts everything above it at risk, and beams tend to go where they meet a post or sit in a wet foundation pocket.
Every structural job is priced after we see it, because no two rot problems are the same size. A few things drive the number:
Every repair is quoted as one fixed price, with structural work starting at $2,500.
If you want a real number, not a rough guess over the phone, we give fixed-price quotes after an on-site look.
We work on homes across Clark County, so we know how the wet season moves through local framing and where rot hides in this area’s housing stock. Calls get an on-site look from a local structural rot repair team.
From older homes near downtown Vancouver to newer builds out east, we repair structural rot throughout the county, including:
Vancouver
Camas
Washougal
Proebstel
Hockinson
Battle Ground
Brush Prairie
Orchards
Felida
Ridgefield

It can be. Rot removes the strength from the wood that holds your home up, so a rotted beam or joist system can sag and, in bad cases, fail. If the damage is in a load-bearing member, it is a safety issue worth addressing now, not later.
The rot keeps spreading. Fungus does not stop on its own, so a repair that is small and affordable today grows into more wood, more labor, and a bigger bill. Waiting also gives mold and termites more time to move in.
We trace the water to where it enters and stop it there, so the repair holds. Keeping gutters clear, grading away from the foundation, and drying out crawl spaces all help keep framing sound.
Less than you would think. Most structural jobs take two to four days, and we work in a contained area, brace as we go, and keep your home supported throughout. We aim to be in, done right, and out.
Every job is quoted as one fixed price after an on-site look, based on the site conditions and the size of the affected area, with structural work starting at $2,500. Financing is available through our payment portal if paying all at once isn’t ideal.
Insurance treats rot as a maintenance issue, not sudden damage, so the repair almost always comes out of pocket. That is why we offer fixed pricing and financing, and why acting early keeps the bill smaller.
Often just the rotted section. We keep what is structurally sound and replace only what is compromised. When joist ends are rotted but the rest is good, we sister in new joists rather than tearing out the whole floor.
We open it up and look. Rot hides behind siding and under floors, so after the first consultation we run a diagnosis once the area is exposed, tracing the moisture to its source so we repair everything affected, not just the visible part.
It depends on the scope. Small repairs often do not, but replacing a load-bearing beam or a large section of framing usually requires a permit, and sometimes a structural engineer’s sign-off, since the work affects how your home carries its weight. We handle the permitting and engineering a repair calls for, and we tell you upfront what yours will need.
Have rot, or think you might? Send us a few details and we'll be in touch to set up a look. For active leaks or urgent structural concerns, call us and ask about an emergency callout.
Have rot, or think you might? Send us a few details and we will get right back to you. For active leaks or urgent structural concerns, call us and ask about an emergency callout.